In addition to the precautions listed throughout this manual, please read and understand the following statements regarding hazards associated with development systems.
* Attention: The ground potential of the Multifunction Power Design Kit is biased to a negative DC bus voltage potential. When measuring voltage waveform by oscilloscope, the scope’s ground needs to be isolated. Failure to do so may result in personal injury or death and equipment damage
* Attention: Only personnel familiar with the drive and associated machinery should plan or implement the installation, start-up and subsequent maintenance of the system. Failure to comply may result in personal injury and/or equipment damage.
* Attention: The surfaces of the drive may become hot, which may cause injury.
* Attention: Multifunction Power Design Kit contains parts and assemblies sensitive to Electrostatic Discharge (ESD). Electrostatic control precautions are required when installing, testing, servicing or repairing this assembly. Component damage may result if ESD control procedures are not followed. If you are not familiar with electrostatic control procedures, refer to applicable ESD protection handbooks and guidelines.
* Attention: Wiring or application errors such as under sizing the motor, supplying an incorrect or inadequate DC supply or excessive ambient temperatures may result in system malfunction.
* Attention: Wait three minutes after removing power from the power drive to discharge the bus capacitors. Do not attempt to service the drive until the bus capacitors have discharged to zero. Failure to do so may result in personal injury or death.
* Attention: Multifunction Power Design Kit is shipped with packing materials that need to be removed prior to installation. Failure to remove all packing materials which are unnecessary for system installation may result in overheating or abnormal operating condition.
Edition 2020-02-28 Published by Infineon Technologies China Co. Ltd., Shanghai, China.
Copyright © 2019 Infineon Technologies China Co. Ltd., All Rights Reserved.
Do you have a question about any aspect of this document? Email: UP.China@infineon.com.
IMPORTANT NOTICE AND DISCLAIMER
The information given in this document shall in no event be regarded as a guarantee of conditions or characteristics or any other kind. The Multifunction Power Design Kit or any the product of Infineon Technologies shall not be used in any application where a failure of the product or any consequences of the use thereof can reasonably be expected to result in personal injury.
WITH RESPECT TO ANY EXAMPLES, HINTS OR ANY TYPICAL VALUES STATED HEREIN AND/OR ANY INFORMATION REGARDING THE APPLICATION OF THE PRODUCT AND CONTAINED IN THIS DOCUMENT, INFINEON TECHNOLOGIES HEREBY DISCLAIMS ANY AND ALL WARRANTIES AND LIABILITIES OF ANY KIND, TO THE FULL AND MAXIMUM EXTENT PERMITTED BY LAW, INCLUDING WITHOUT LIMITATION WARRANTIES OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY RIGHTS OF ANY THIRD PARTY.
In addition, any information given in this document is subject to user’s compliance with its obligations stated in this document and any applicable legal requirements, norms and standards concerning any use of Multifunction Power Design Kit or any product of Infineon Technologies in the intended applications. The data contained in this document is exclusively intended for technically trained staff and for training purpose only. It is the responsibility of user to evaluate the suitability of the product for the intended application and the completeness of the product information given in this document with respect to such application.
WARNINGS
Due to technical requirements products may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies office.
