服装模特用无碱玻璃纤维短切毡是由无碱玻璃纤维合股无捻粗纱短切后，随机无定向均匀平铺，然后再用粘合剂粘合在一起而制成连续性的毡片。
E-glass Chopped Strand Mat For Fashion model are an unwoven fabric consisting of randomly distribute chopped strands held together with binder.
适用树脂和产品Compatible Resins and Applications
适用于增强不饱和聚酯树脂、乙烯基树脂、环氧树脂等。
服装模特用无碱玻璃纤维短切毡主要应用于模特衣架的制作
Chopped strand mat are compatible with unsaturated polyester.vinyl ester and epoxy resins
The products are mainly used in Model hanger
产品特点Product Features
1、单位面积质量均匀，保证了制品的玻璃纤维含量和力学稳定性
2、毡片粘结剂分布均匀，保证粘接良好、掉纱少，同时使毡卷直径小
3、毡层的结构设计是毡具有优良的柔韧性，操作时贴模性好，小角度情况不回弹
4、树脂浸穿浸透快且速度一致，易排除气泡，降低树脂耗用和生产成本，同时提高工作效率和最
终制品的力学性能。
5、制品干、湿态强度高，并且透明性好。
1.Uniform density ensures consistent fiberglass content and mechanical properties of the composites products.
2.Uniform binder distribution ensure good mat intergrity.little loose fibers and small roll diameter.
3.Excellent flexibility ensures good moldability with no springback at sharp angles.
4.Fast and consistent wet-out speed in resins and rapid air release reduce resin consumption and cost and enhance productivity and mechanical properties of the end products.
5.The composite products have high dry and wet tensile strength and good transparency
技术指标
包装及储存说明 Pack8ging＆Storage
服装模特用无碱玻璃纤维短切毡缠绕在内径79mm、99mm或106mm的纸管上，按照产品要求可做成200米/卷、300米/卷.500米/卷，用塑料防潮袋包扎，外用纸箱或牛皮纸包装．垂直或水平放置。
装入集装箱时可散装也可用托盘包装。
Each chopped strand mat is wound onto a paper tube which has an inside diameter of 79mm，90mm or 106mm，the products can be made in 200m/roll, 300m/roll or 500m/roll according To customer request，wrapped up with plastic film and then be packed in a cardboard box or wrapped up with Kraft paper The rolls can be vertically or horizontally Placed. The rolls can be loaded into a container directly or on pallets
在没有特殊要求的情况下，服装模特用无碱玻璃纤维短切毡储存在干燥凉爽的地方防止雨淋。储存控制温度15℃一35℃-湿度35%-65%。为了确保产品安全、避免损坏产品，托盘的堆码高度不超过两层；无托盘水平放置不超过4层。
Unless otherwise specified.E-glass chopped strand mat should be stored in a dry.coal and rain-proof area .it is commended that the temperature and humidity should be always maintained at 15℃-35 and35%-65%respectively
To ensure safety and avoid damage to the product, the pallets should not be stacked more than two layers.Any package without pallet should not be stacked horizontally more than four layers.